IPC-A-620 Specialist

Day 1

Module 1: Policies and Procedures, General and Applicable Documents, Preparation, Measuring Cable Assemblies and Wires, Testing Cable Assemblies, and Review and testing

Module 2: Crimp Terminations, and Insulation Displacement

Day 2

Module 3: Soldered Terminations, High Voltage, and Review and testing

Module 4: Connectorization, Molding/Potting, and Review and testing

Day 3

Module 5: Ultrasonic Welding, Splices, and Review and testing

Module 6: Marking and Labeling, Wire Bundle Securing, Finished Assembly Installation, and Review and testing

Day 4

Module 7: Coaxial and Biaxial Assemblies, and Review and testing

Module 8: Electrical Shielding, Cable/Wire Harness Protective Coverings, and Review and testing

Day 5 (Optional)

Module 1: Lab Overview, Review harness assembly print, materials and tooling

Module 2: Wire Prep and Solder Termination – no soldering, Cut and semi-stripping five wires, Install wires onto the harness board

Module 3: Lug Crimp Terminations, Cut, strip and crimp two styles of lug-type terminals, Install wires onto the harness board

Module 4: Pin Crimp Terminations, Cut, strip and crimp two styles of pin terminals, Install wires onto the harness board

Module 5: Coaxial Terminations, Cut, strip RG59 wire; assemble two coaxial connections, Install wires onto the harness board

Module 6: IDC Terminations, Cut, strip CAT5 wire; crimp two IDC connectors, Install wires onto the harness board

Module 7: Mass Terminations, Cut, ribbon cable; crimp two mass termination connectors

Module 8: Harness Securing, Secure the cable using tie-wraps and lacing cord