Webinars - EPTAC - Train. Work Smarter. Succeed

Assembly – Understanding the HARD(ware) Side of IPC-A-610 - EPTAC - Train. Work Smarter. Succeed

Written by EPTAC - Train. Work Smarter. Succeed | Mar 19, 2008 4:00:00 AM
 
 

Course Length: 40 Minutes | Cost: FREE | Presenter: Leo Lambert

The Accept/Reject Criteria for soldered joints right? That is what IPC-A-610 “Acceptability of Electronic Assemblies” is all about. Well, yes and no. There is a lot more that goes into an assembly than just soldered connections. This HARD(ware) from the board, screws, wire, handles, latched, heat sinks and formed components all have criteria that must be met by IPC-A-610 too. This webinar takes a look at these requirements and their impact on a final assembly.

Topics we will be reviewing are:

  • General hardware installation.
  • Tolerances and torque requirements.
  • Component mounting, forming and orientation.
  • The impact of bow and twist during post assembly.